 |
The Strips were laid out ready to go. One more check with the the laser level, a little packing to make it all level end to end and side to side.
This strip has a bead on both edges and has tapered ends to allow it to conform to the required curves of the bow and stern. Using the jigs prepared earlier and clamps to hold the strip in place I then hot glued the strip at each station and glued the tip to the bow piece.
|
 |
| View from the bow. there is quite a curve over the last 3 stations. |
 |
| Along the side the strip is pretty straight. |
No comments:
Post a Comment